Scrapbooking 201: Soda Tab Buckles

Soda Tab Buckles

Supply List:

Tabs off of pop can
Tweezers
Embossing ink
Embossing powder
Heat Gun
Hammer
Nail file or sand paper

1. Remove tab from old pop can. Clean it. Hammer down any sharp pieces with hammer.
2. Rough up the surface a little bit with a nail file or some sandpaper.
3. Use the tweezers and hold the tab, cover HALF of the tab with the embossing ink and then dip into embossing powder.
4. Use heat gun and heat the powder until melted.
5. Repeat on other half of tab.
6. Repeat steps 3-5 to get a more finished look. You can also use UTEE if you prefer.
7. Let cool and slip onto your ribbon.